GENISYS PROTOCOL DRIVER

Press SW1 as required to bring up CX on display. On both ends of cable, identify spare wires using the applicable wiring diagram. Write switch-set or default values to memory? If the 5V on-board power LED does not light, the board may not be receiving external power. When last address in sequence is entered, PC should display option of writing values entered to this point into configuration file, or entering displayed default values. External connections to the bit boards are made on a way PCB edge connector that projects through backplane slots in the cardfile. N N N N N?

Uploader: Mut
Date Added: 21 July 2005
File Size: 21.89 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 58906
Price: Free* [*Free Regsitration Required]

Office protocol converter applications are included for reference refer to SMD for details. Or, it can accept proticol 22 wires with a maximum outside diameter of. In the strobe mode, the isolators are set high only during the 0.

Wireshark ยท Wireshark-dev: [Wireshark-dev] New dissector: packet-genisys.c

This is indicated by the letter D in [brackets] at the end of the parameter line. To set relay output board control delivery time, press SW2 once, then press SW1 as required to select option. N Code Line Interface: When these bits are not prrotocol agreement, output bits are not accepted for delivery to external circuits.

Display should go dark. Some commands have subroutine levels.

GENISYS SERIES 2000 – Ansaldo STS | Product Support

When valid Slave port baud rate is entered, PC should display next parameter. An input of the proper voltage actives an opto isolator 32 totalwhich serves to electrically isolate any external voltage transients from PCB protockl system internal circuits.

Related Drivers:  XEROX DOCUMATE 250 DRIVERS DOWNLOAD

Make certain the board is fully inserted in the cardfile or card enclosure. Result To set Master port key-on delay, press SW2 Also confirm that all contact pins are present and properly connected to their respective wires. The MC is driven by a 10 MHz clock signal. Repeat steps 8 and 9 to select the Slave port key-off delay.

No other adjustments are required prior genidys installation. When either option is selected, the display should return to LD. When last value in sequence is entered, PC should display option of writing values entered to this point into configuration file, or entering displayed default values. NOTE The troubleshooting procedures given in this section focus on possible problems with the Enhanced Controller board.

The HELP command can be consulted at any time during the configuration process. Figure Data outputs from the Enhanced Controller PCB via 8-bit cardfile bus are locked in four 8-bit storage buffers, each in genists. When last address in sequence is entered, PC should display option of writing values entered to this point into configuration file, or entering displayed default values.

The Service Shop Russell St. PC should show example: The first three groups of eight inputs requires the same common voltage on all inputs, while different commons may be applied to each of the last group of eight inputs Ref.

Related Drivers:  LASERJET IIP PLUS DRIVER

If any parameter values must be changed, SW1 is pressed again to cycle the alphanumeric display back to the first parameter in the menu. If S2 Geisys port key-off delay is to be entered or changed, continue with step It is not an isolated command that must be gdnisys and exited separate from the operational commands. The Universal Slave serial interface port supports both synchronous and asynchronous interfaces and is an RS compatible implementation of RS Same displays as Slave port baud rate apply to Master port baud rate.

This jumper configures a single mode prohocol circuit that controls the delivery mode of all 32 outputs. IF S2 stop bits are to be entered or changed, continue with step Same displays as Slave key-on delay apply to Master key-off delay.

Check the board material for fractures or other physical damage. Replace these PROMs as necessary. Typical Construction Procedure Ref.